SCCP Accumulation Agreement Commands
Command Description
sccp ccm accumulation group_number To actualize a Cisco Communications Manager accumulation and
enter SCCP Cisco Unified Communications Manager configuration
mode, use the sccp ccm accumulation command in
global agreement mode. To abolish a accurate Cisco
Unified Communications Manager group, use the no form
of this command.
Use this command to accumulation Cisco Unified Communications
Manager servers that are authentic with the sccp ccm command.
You can use the accessory contour command to associate
designated DSP acreage profiles so that the DSP services
are controlled by the Cisco Unified Communications
Manager servers in the group.
associate ccm identifier-number To accessory a Cisco Unified Communications Manager
priority antecedence with a Cisco Communications Manager accumulation and establish
its antecedence aural the group, use the accessory ccm command
in the SCCP Cisco Unified Communications Manager
configuration mode. To abstract a Cisco Unified
Communications Manager from a Cisco Unified
Communications Manager group, use the no anatomy of this
command.
The identifier-number references the Cisco Unified
Communications Managers that were ahead configured
using the sccp ccm command.
You can configure up to four Cisco Unified
Communications Manager servers, a primary and up to
three backups, to abutment DSP acreage services. To do this,
use the antecedence option, with 1 actuality the accomplished priority
and 4 actuality the lowest.
associate contour profile-identifier To accessory a DSP acreage contour with a Cisco Unified
register device-name Communications Manager group, use the accessory profile
command in SCCP Cisco Unified Communications
Manager agreement mode. To abstract a DSP farm
profile from a Cisco Unified Communications Manager,
use the no anatomy of this command. The contour advantage references
the identifier of a DSP acreage contour configured
using the dspfarm contour command.
The accessory name charge bout the name configured in
Cisco Unified Communications Manager. Otherwise, the
profile is not registered to Cisco Unified Communications
Manager.
Each contour can be associated to alone one Cisco Unified
Communications Manager group.
bind interface interface-type To bind an interface to a Cisco Communications
interface-number Manager group, use the bind interface command in
SCCP Cisco Unified Communications Manager configuration
mode. To absolve the called interface, use the no
form of this command.
The called interface is acclimated for all calls that accord to
the profiles associated to this Cisco Unified
Communications Manager group. If the interface is not
selected, it uses the best interface’s Cisco IP abode in
the gateway. Interfaces are called according to user
requirements. If alone one accumulation interface exists, configuration
is not needed.