The appearance anatomy map Command
The appearance anatomy map command displays the Network layer–to–DLCI mappings. Here’s how
that looks:
RouterB#show anatomy map
Serial0 (up): ipx 20.0007.7842.3575 dlci 16(0x10,0x400),
dynamic, broadcast,, cachet defined, active
Serial0 (up): ip 172.16.20.1 dlci 16(0x10,0x400),
dynamic, broadcast,, cachet defined, active
Serial1 (up): ipx 40.0007.7842.153a dlci 17(0x11,0x410),
dynamic, broadcast,, cachet defined, active
Serial1 (up): ip 172.16.40.2 dlci 17(0x11,0x410),
dynamic, broadcast,, cachet defined, active
Notice that the consecutive interfaces accept two mappings—one for IP and one for IPX. Also
important is that the Network band addresses were bound with the activating protocol
Inverse ARP (IARP). After the DLCI cardinal is listed, you can see some numbers in parentheses.
The aboriginal one is 0x10, which is the hex agnate for the DLCI cardinal 16, acclimated on serial
0. And the 0x11 is the hex for DLCI 17 acclimated on consecutive 1. The additional numbers, 0x400 and
0x410, are the DLCI numbers configured in the Anatomy Relay frame. They’re altered because
of the way the $.25 are advance out in the frame.