Now that an end-system network topology diagram has been explained, let’s go through the
steps to create one. Because most end-system network topology diagrams are built on the network
topology diagrams, the standard symbols set that was used in the network diagrams will
also be used here in the end-system network topology diagram. In addition, there will be symbols
to indicate servers, workstations, and other network attached end systems.
The other information added to the end-system network topology diagram is a subset of the
data in the end-system network configuration table. Figure 35.2 shows how this data maps to
the topology diagram.
As you can see in Figure 35.2, the servers entered in the network configuration are shown in
their appropriate place in the network. Only the key information on the servers was transferred
to the topology diagram to keep it from becoming too cluttered. Also, as mentioned earlier in
this discussion, notice in the upper-left of the diagram that a grouping of computers was used
instead of showing all 12 of the Seattle users’ computers. This simplifies the drawing without
sacrificing too much detail. If more detail is needed, specifically on the Seattle office, a new endsystem
network topology diagram could be created specifically for that office.
Well, after what seems like an eternity, you have completed your network configuration
tables, network topology diagrams, end-system network configuration tables, and end-system
network topology diagrams! Now you just have to make sure that you keep them accessible and
update them any time there’s a change in the network. Also, remember to print hardcopies regularly,
so that you will still have your documentation if the network is down.
1076