Disabling Failover

Disabling Failover

To attenuate failover, use the no anatomy of the failover command:

PIX1(config)# no failover

To verify that failover has been disabled, use the appearance failover command:

PIX1# appearance failover

Failover Off

Cable Status: My ancillary not connected

Reconnect timeout: 0:00:00

If you are disabling failover permanently, it is awful recommended that you

clean up your agreement by removing the added failover commands. In our

example, access the afterward commands on the primary firewall:

PIX1(config)# no failover ip abode central 192.168.1.2

PIX1(config)# no failover ip abode alfresco 10.5.1.2

PIX1(config)# no failover ip abode accompaniment 172.16.1.2

PIX1(config)# no failover articulation state

It would be best to abolish the agreement absolutely from the secondary

firewall.