Configuring EIGRP Butt Routing
The Security Appliance can be enabled as an EIGRP butt router through the afterward steps:
Step 1. Enable the EIGRP acquisition action from the all-around agreement approach as follows. The as-num is the
Autonomous System cardinal of the EIGRP acquisition process:
firewall(config)# router eigrp as-num
Step 2. Configure the interface affiliated to the administration router to participate in the EIGRP process:
firewall(config-router)# arrangement ip-addr [mask]
Step 3. Configure the Security Appliance for the butt acquisition process. Specific networks charge be explicitly
defined that charge to be advertised by the butt acquisition action to the administration router. By default,
static and affiliated networks are not automatically redistributed into the butt acquisition process.
firewall (config-router)# eigrp butt {receive-only | [connected] [redistributed] [static]
[summary]}
By default, EIGRP accost packets are beatific as multicast packets. In a nonbroadcast ambiance such as a tunnel,
EIGRP neighbors charge be manually authentic to accelerate accost packets as unicast messages. To ascertain a static
neighbor in EIGRP, use the afterward command from the router agreement mode:
firewall(config-router)# acquaintance ip-addr interface if_name
Multiple changeless neighbors can be authentic application the ahead categorical process.
Similar to EIGRP abutment in a Cisco IOS router, several added alternative ambit can be configured on Security
Appliance, such as the distribute-list, passive-interface and default-information commands.