OSPF Commands
To configure OSPF on your Security Appliance, you use various commands. To enable OSPF
on your PIX Firewall, you use the router ospf command. The syntax is as follows:
router ospf pid
The pid represents a unique identification for the OSPF routing process in the range from 1
to 65,535. Each OSPF routing process on a single Security Appliance must be unique, and
Security Appliance Version 6.3 supports a maximum of two different OSPF routing
processes.
After you issue the router ospf command, the Security Appliance command prompt enters a
subcommand mode indicated by a command prompt similar to the following:
pix515a(config-router)#
In subcommand mode, you can configure various OSPF parameters (see Table 11-9).