multicast interface Command
The multicast-routing command enables PIM and IGMP on all interfaces. The syntax for this
command is
[no] multicast-routing
mroute Command
To configure your Security Appliance to forward multicast traffic when the multicast router
is on the inside interface, you need to use the mroute command. The syntax for this
command is as follows:
mroute source source-mask in-interface dest dest-mask out-interface
The parameters for the mroute command are shown in Table 11-13.
Table 11-13 mroute Command Parameters
Parameter Description
source The source address of the multicast transmission device
source-mask The network mask associated with the multicast source address
in-interface The interface on which the multicast traffic enters the Security Appliance