A Cisco 1841 router
An 1841 router holds most of the same interfaces as a 2800 router, but it’s smaller and less
expensive.
Setup Mode
If the router has no initial configuration, you will be prompted to use setup mode to establish
an initial configuration. You can also enter setup mode at any time from the command line by
typing the command
setup
from something called
privileged mode
. Setup mode covers only
some global commands and is generally just not helpful. Here is an example:
Would you like to enter the initial configuration dialog? [yes/no]:
y
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]:
y
Configuring global parameters:
Enter host name [Router]:
Ctrl+C
Configuration aborted, no changes made.
You can exit setup mode at any time by pressing Ctrl+C.